NAME

grml-sniff - script for configuring a network sniffing setup

SYNOPSIS

grml-sniff [OPTIONS]

DESCRIPTION

This manual page documents briefly the grml-sniff command. grml-sniff is a script for configuring a network sniffing setup. It does NOT sniff on a hub/switch but instead sets up a man-in-the-middle (MITM) configuration using a bridge device with two network devices.

OPTIONS

start

Start sniffing setup.

stop

Stop sniffing setup (set interfaces down and remove bridge device).

restart

Restart grml-sniff.

status

Display status of configuration.

info|-h|--help

Show usage information.

Usage example

This section describes the setup and configuration for capturing network traffic on a setup like follows (assuming the Sniffing Computer is the box where you are using Grml with grml-sniff):

Hub/Switch/Router
       ^
       |
       | Interface known as 'eth0' in the documentation
       |
       |
       v            Interface known as 'eth2'
Sniffing Computer <---------------------------> Control Computer (optional,
       ^                                        providing GUI, Wireshark,
       |                                        Backup of dumpfiles, etc)
       |
       | Interface known as 'eth1' in the documentation
       |
       v
 Client System

Disable DHCP

Start with booting Grml using the nodhcp bootoption. This makes sure that no network configuration is being executed automatically while booting. If you booted your Grml system without the nodhcp option by accident, just execute killall pump; killall dhclient after booting finished to make sure there aren’t any running DHCP clients anymore.

After booting finished check out the available network interfaces:

ifconfig -a

At least two interfaces should be present (usually named eth0 and eth1, that’s what we are using in this documentation as well). Make sure the network cards are connected with the hub/switch/router and the client accordingly! The third interface (known as eth2 in this documentation) is just optional and not necessary for sniffing itself.

Simple (but not necessarily 100% reliable) check for network connection using a software command:

ethtool eth0
ethtool eth1
ethtool eth2

Look for Advertised auto-negotiation: Yes and Link detected: yes.

Configuration

Make sure the according network interfaces are configured as BRIDGE_DEVICES in /etc/grml/router-setup. If you are using eth0 and eth1 you don’t have to do anything (the default is just fine)! Otherwise adjust BRIDGE_DEVICES in /etc/grml/router-setup accordingly. For example if the devices you would like to use within the sniffing bridge are named eth2 and eth4 use:

BRIDGE_DEVICES='eth2 eth4'

Start sniffing setup

Assuming you configured /etc/grml/router-setup as documented in the previous section, finally invoke grml-sniff:

grml-sniff start

That’s it. Now your system should be set up accordingly for capturing network traffic.

Capturing traffic

Execute:

tcpdump -s0 -C 50 -v -w pcap -i br0

to generate files named pcap, pcap1, pcap2,… each with a file size of ~50MB. Press CTRL-C to stop capturing traffic. You can analyse the generated pcap files for example using wireshark(1).

See also

grml-ap(8), grml-bridge(8), grml-router(8)

AUTHOR

grml-sniff was written by Michael Prokop <mika@grml.org>.